***PURCHASE AN INNOFADER:*** |
|
|
FADER SLOT: Crossfader Only |
_______________________________________________ |
|  |
| SUGGESTED HEIGHT ADJUSTMENT: Raise by 2.5mm.
More info |
| ADAPTER CABLE: 3 pin small. Cable can be forward or reversed. |
| OPTIMAL CURVE DIAL SETTING: 2:30 |
| |
_______________________________________________ |
|  |
| SUGGESTED HEIGHT ADJUSTMENT: Raise by 2.5mm.
More info |
| ADAPTER BOARD (included): Adapter (5) |
| OPTIMAL CURVE DIAL SETTING: 2:30 |
| |
_______________________________________________ |
|  |
| SUGGESTED HEIGHT ADJUSTMENT: Lower by 1.5mm.
More info |
| ADAPTER CABLE: 3 pin small. Cable can be forward or reversed. |
| |
_______________________________________________ |
Installation Notes: |
| Use included flathead screws for more headroom between the mixer faceplate and the crossfader plate. |
| Multiple Innofader models will work for this mixer. The preferred model is listed first based on the best performance / cost tradeoff. |
| Use 1.2mm raised cap to prevent the knob from scraping against the faceplate (full bodied Innofader models only) |
| Also fits the original Innofader Pro. Please follow the instructions for VCA hookup |
Installation Detailed Description: |
| Please check the Mechanical Fitting instructions for increasing the stem height. Note on the Innofader PNP and mini Innofader PNP P that the right 3 pins of the 3 pin small cable are used which is illustrated here. Otherwise the Innofader Pro2 uses adapter (5) and the Innofader Pro uses the J43 socket. |
