Community
Forum archive
Threads from the old Audio Innovate forum.
QFO Installation
I've had customers successfully fit the Innofader into the Vestax QFO but it's a bit tricky. You need to do ALL of the following to make it work.
1) Make sure that any point where the Innofader touches the Vestax circuit boards that the contact points have electrical tape to isolate them.
2) Tape an insulating washer to each Innofader hole.
3) Use the slotted insulating screws included with the Innofader kit to mount the Innofader.
4) If the fader cap rubs against the faceplate, put a small piece of tape under it to raise it up, and wrap the stem with double sided tape to keep the knob from slipping.
