Community

Forum archive

Threads from the old Audio Innovate forum.

Roland DJ 1000



I came across a mint condition Roland DJ 1000 and couldn't pass it up. This mixer has a very warm and bassy analogue sound and of course the wicked filter section. The only problem was the pathetic faders.? I immediately contacted Elliot and was told that an Innofader Pro 2 could work if I could find a way to mount it.. The problem becomes obvious as soon as you pull out the stock crossfader, there is a circuit board right in the way. With further advice from Elliot I decided to give it a go. The hardest part was taking the risk of cutting the circuit board, however, with a dremel it was actually very easy. Connecting the Innofader to the mixer was done by making an adaptor from the #13 adaptor board and the harness clip from the Roland crossfader. I used two electrical diagrams to figure out the connections.? After testing it out I was very happy and relieved to find that it worked! Here are some pictures of the process.

post-33389-0-18002900-1591407479.jpg

post-33389-0-72028500-1591406226.jpg

?

This picture shows how to cut the board:

post-33389-0-46431100-1591406348.jpg

?

Reconnection of wires after you cut the PC board:

post-33389-0-35332700-1591406439.jpg

?

Next two pictures show how to connect power from the mixer to the adapter board:

post-33389-0-64336000-1591406769.jpg

post-33389-0-72415000-1591405948.jpg

?

Now this is how you connect the crossfader wires:

post-33389-0-74024400-1591407138.jpg

post-33389-0-13147100-1591406985.jpg

post-33389-0-82833000-1591407246.jpg

?

?

?

?

?

?