Forum archive
Threads from the old Audio Innovate forum.
Vestax PCV-275 with the Innofader Pro
9/20/2015 Edited to include Innofader Pro2 notes.
The Vestax PCV-275 installation requires a small amount of soldering.
For the Innofader Pro: It is similar to the "ALTERNATE CONFIGURATION" shown here. The only difference is that only a single 3 wire power cable is required.
For the Innofader Pro2: Please use adapter (14) along with the 2 wire cable.
To connect the wire, first turn off your mixer, open your mixer and locate the power supply PC board. It's at the top center of this picture.
The power supply board looks like this when removed.
Locate the two power supply ICs. They are marked "7815A" and "BA15"
For the Innofader Pro: On the 3 wire cable - the rightmost cable in this picture - cut the connector off one end and strip the wires about 1/8". Then solder the wires to the bottom of the power PC board as shown here. Make sure to match the red and black wires to the correct pins as shown. It is not important which red wire connects where as long as they are both connected separately.
For the Innofader Pro2, use a 2 wire cable. First cut the connector off one end and strip the wires about 1/8". Connect these 2 wires red and black as shown:
v v
When you are done, the top side of the power PC board will look like this
For the Innofader Pro2, only the 2 wires marked are used:
v v
Continue below for Innofader Pro only:
Now wire up the Innofader as described above for the ALTERNATE CONFIGURATION. The crossfader cable should plug in as shown. The opposite end of the 3 wire cable that you soldered to the mixer plugs into J37, but J36 is left empty:
Make sure before you put your mixer back together that you place an insulator tube over the non-VCA adapter board to prevent it from shorting to the mixer.
