Community

Forum archive

Threads from the old Audio Innovate forum.

NS6 with the Innofader Pro



Hey all,

The NS6 will work with the Innofader Pro once you do the wiring mods as shown below.

First, start with the Standard VCA hookup as shown here. The Numark crossfader connector goes to J43 on the VCA adapter board.

Also locate the smaller 2 wire cable that fits into the J14 and J15 slots. You'll need this cable for the mods.



For the 2 wire cable, remove the red and black wires from both connectors. Remove the wires by lifting up on the connector tabs and pulling out the wires as shown here:



So now you have 2 empty 2 pin connectors available. Take this cable and rewire it as follows:
"A": Remove the yellow and green wires from the 8 pin Innofader 8 wire cable from the pins closest to IC9. Hook these wires up to a 2 pin connector and plug into J15. Make sure the yellow wire is the one closest to J10 also marked "LF POWER".
"B": Remove red and black wires from the first and third pins on J43. Pin 1 is the pin closest to J17. Reconnect these wires to the other 2 pin connector and plug into J14. Make sure the black wire is the one closest to the J14 text.



Now a few other hints with this modification:
1) It may be difficult to use the insulated tubes that are included with the Innofader Pro with this mod. Use electrical tape wherever necessary.
2) The Innofader just barely fits in the NS6. Please make sure that you put electrical tape on the bottom of the Innofader, and if necessary, use the washers included with the Innofader to raise the fader plate slightly so the Innofader fits.