Forum archive
Threads from the old Audio Innovate forum.
Xone:62 Innofader Pro Mod
XONE:62 MOD
The 2.5V power supply on the Xone:62 is current limited and cannot source enough power to run a digital fader like the Innofader. In addition, on newer P&G models, a mod is recommended to sharpen the fader curve on the "sharp" mixer setting. This will allow you to get both a good mix curve and cutting action with the Innofader CURVE dial set in the middle.
XONE:62 2.5V POWER SUPPLY BOOST (MANDATORY)

Solder a 2.2k resistor in parallel with R121 as shown in the picture. The resistor should be rated for 1/8W or 1/4W. The part shown in the picture is an SMD part but a through hole part is easier for assembly. You can purchase the part here.
XONE:62 CUT SHARPENER (OPTIONAL)

Solder two 200 ohms resistor as shown in the picture, one in parallel with R106 and the other in parallel with R117. The resistor should be rated for 1/8W or 1/4W. The part shown in the picture is an SMD part but a through hole part is easier for assembly. You can purchase the part here.
INNOFADER MOD
This Innofader modification is for all versions of the Allen and Heath Xone:62 mixer. Please do not do this modification on any other mixers unless there is a specific instruction to do so.
For the Innofader Pro and Pro2 it is necessary to do this because the Xone:62 power supply to the crossfader is only 2.5 volts. The Innofader VCA adapter reduces this voltage to 1.9 volts, and the modification boosts it back to 2.3 volts which is enough to make the Innofader work.
INNOFADER PRO2 INSTRUCTIONS
Please click on this link to view the instructions:
https://www.innofader.com/images/Xone%2062%20mod/Xone_62_InnoPro2%20Rev.%202.jpg
INNOFADER PRO INSTRUCTIONS
First take the 2 wire cable included with the Innofader pro with the smaller 2.0mm spacing between the pins and plug it into the middle 2 pins of J43 as such:
Then remove the red wires on both the 5 pin cable which plugs into J5 on the Innofader Pro body and on the 2 wire cable.
Take these two wires and swap them, and the result will look like this:
Finish the installation by plugging the A&H crossfader cable into J40 and insulating the adapters as shown in the standard instructions for the Innofader Pro. Just make sure to keep the wiring modification as shown here.
