Numark SM-3 wiring mod

MOD USING THE INNOFADER PRO

For this mod, you need to modify the mixer cable as follows. Make sure that pins 1-4 connect to J40 on the VCA adapter and pin 5 is not connected



MOD USING THE ORIGINAL INNOFADER

The Numark SM-3 uses a unique wiring system. In the following picture, the modded cable is on the left and the original cable is on the right.



So the order of the wires is as such:

5 pin connector:
pin 1 grey
pin 2 blue
pin 3 yellow
pin 4 green
pin 5 not connected

4 pin connector:
pin 1 grey
pin 2 yellow
pin 3 green
pin 4 blue

Note there are a few options for doing this modification:
1) You can use the original 4 pin connector to do the modification. You will need to use a good needle-nosed pliers to pull out the pins and put them back in. However, you need to be extra careful when you plug in the mixer connector that the unconnected cable socket pin is next to the green wire and not next to the grey wire.
The modded cable will then look like this:


2) You can contact Audio Innovate for service and we will do the modification for you using a 5 pin connector.