Innofader - connectivity

Instructions for Numark DXM-06

***PURCHASE AN INNOFADER:***

FADER SLOT: Crossfader Only

_______________________________________________

COMPATIBLE INNOFADER #1:
Innofader PNP3

SUGGESTED HEIGHT ADJUSTMENT: Raise by 2.5mm. More info
ADAPTER CABLE: 3 pin small. Cable can be forward or reversed.
OPTIMAL CURVE DIAL SETTING: 2:30
 

_______________________________________________

COMPATIBLE INNOFADER #2:
Innofader Pro2

SUGGESTED HEIGHT ADJUSTMENT: Raise by 2.5mm. More info
ADAPTER BOARD (included): Adapter (5)
OPTIMAL CURVE DIAL SETTING: 2:30
 

_______________________________________________

COMPATIBLE INNOFADER #3:
mini Innofader Plus

SUGGESTED HEIGHT ADJUSTMENT: Lower by 1.5mm. More info
ADAPTER CABLE: 3 pin small. Cable can be forward or reversed.
 

_______________________________________________

Installation Notes:

Use included flathead screws for more headroom between the mixer faceplate and the crossfader plate.
Multiple Innofader models will work for this mixer. The preferred model is listed first based on the best performance / cost tradeoff.
Use 1.2mm raised cap to prevent the knob from scraping against the faceplate (full bodied Innofader models only)
Also fits the original Innofader Pro. Please follow the instructions for VCA hookup

Installation Detailed Description:

Please check the Mechanical Fitting instructions for increasing the stem height. Note on the Innofader PNP and mini Innofader PNP P that the right 3 pins of the 3 pin small cable are used which is illustrated here. Otherwise the Innofader Pro2 uses adapter (5) and the Innofader Pro uses the J43 socket.