Community
Forum archive
Threads from the old Audio Innovate forum.
SA-5 Installation (and SA-3)
We've received various requests to fit the Innofader on the Stanton SA-5. I personally have fitted this mixer and it works great. There are just a few "tricks" to making the installation process easy.
First we suggest you use the curve and cut-in settings as shown below. This will allow you to use all 3 styles of mixer curve on the SA-5 and have them work properly:
Now please remove both the fader section plate and the bottom cover. You can do this by removing all of the screws on the bottom and 2 sides except for the 2 screws per side for the top section plate.
Now remove the original crossfader and install just the adapter plate from the Innofader kit as shown below. ***Please tighten the screws extra tight, otherwise the adapter plate will jiggle around when you scratch.
Install the Innofader from the bottom with the label facing the front of the SA-5.
For the cables, connect the original mixer crossfader cable to the J16 Stanton adapter on the Misc. Adapter board, and plug the Innofader cable from the adapter board to the Innofader.
VERY IMPORTANT!!! Before you put the mixer back together, please secure the Innofader adapter board and cables using the 2 bind ties included with the Innofader kit. Make sure that you secure everything so that there is not danger of metal parts from the adapter board or Innofader cable to touch other mixer parts or the mixer cover. In case you have any doubts, you can always wrap the parts with electrical tape for extra security.
