Community
Forum archive
Threads from the old Audio Innovate forum.
Tascam XS-4, XS-8, Ecler HAK300/310/320 Innofader Pro mod
We've discovered that these mixers require an external power hookup to the Innofader Pro. To do this first power off the mixer, unplug the power, open the mixer, and locate the power supply cable inside the mixer. It is the yellow, black, and brown cable coming from the section inside the red circle.
***You will need the following tools to do this:
Screwdriver (to open the mixer)
Wire cutter and stripper (to splice the wires)
Electrical tape
A soldering iron + solder will make a more reliable connection but is optional.

You will need to do the "VCA HOOKUP FOR INNOFADER PRO USING EXTERNAL MIXER POWER" as shown here: http://www.innofader.com/installations.php?id=6&pid=2. The only tricky part is for step "E", you will need to do the following:
1) Strip the yellow and black wires where the electrical tape is shown below.
2) Take the 3 wire cable (black, red, black) included with the Innofader Pro, cut off one end, and strip the 3 wires.
3) Connect red to yellow, black to black as shown. ***Make sure you use the red wire which connects to the red dot marked in step E above. Make sure the other black wire is either clipped off or covered in electrical tape. You can either twist the wires together, or for a better connection, solder them together.

